What green floor tiles covers
This collection gathers every tile on the site that carries both the green colour tag and the floor tile application tag. It is the smallest of the colour floor pages, and the listings come from a handful of ranges: Tamarama, St Kilda, Mooloolaba, Cottesloe, Briq, Meander and Matrix. They share a colour and a use, but the formats differ a lot. There is a 300 x 300mm encaustic pattern, an octagon and dot, a gloss penny round, a honed marble mosaic, an unglazed porcelain mosaic, a fish scale and a marble look in 200 x 200mm. Sizes, finishes and slip ratings sit on each listing, so this guide stays with what the listings print and with how green behaves on a floor.
Two sister pages cover the same ground from other angles. Green tiles holds the colour across walls and floors, including the shades and formats that do not carry the floor tag, and floor tiles holds the use across every colour. The tiles hub links every category on the site. For a wet room, bathroom tiles adds the wall view. The same floor view in other colours is at white floor tiles, grey floor tiles, beige floor tiles and black floor tiles.
One caution applies to the whole page. The floor tag is applied to tiles whose listings describe themselves very differently. One mosaic prints a wear rating of 1 with the line Not recommended for floors. One octagon prints a wear rating of 2 for light traffic with soft soled shoes. One mosaic prints no slip rating. Read the slip, wear and area lines on the tile you like before it goes on a floor plan. The sections below show where each listing sits.
Shades of green on a floor
A UK tile retailer's green bathroom guide describes green tiles as glazed ceramic or porcelain in colourways from pale sage and mint through to olive, emerald and deep forest. A national tile retailer says green is good in every shade, from dark forest tones to country sage, and calls it a colour that can act as a neutral or as a statement. The listings here sit mostly at the soft end: Soft Sage, Sage, Mint and Marine on the tile faces, with a deeper Ming Green in the marble and a green dot on the cream and white octagons.
A UK tile retailer describes muted sage as a quiet backdrop and deep forest as a feature colour. On a floor, that translates into a choice. A soft sage floor sets the tone for a room without dominating it, and a deep green floor becomes the room's main feature. The deeper green on this page is the Ming Green marble, where the variation in the stone does the work.
An Australian building materials retailer lists whites, greys and natural timber as the usual companions for green, and says darker greens make brass and gold stand out. A floor in sage or mint takes the same pairings, and the other colour floor pages linked above show those companion floors in white, grey and beige.
The UK retailer's guide goes further and calls green the one colour that reads as calming and natural in almost every light condition, which is why it says green has moved from an occasional accent to one of the most requested bathroom tile colours. That is a retailer's claim and not a measured one, but it explains why a soft sage or mint floor is a common choice for a bathroom or ensuite, and why the listings on this page lean that way. A floor is also the largest surface in a small room, so the shade matters more underfoot than it does on a single feature wall. Checking a sample against the wall colour, the vanity and the window in daylight and in the evening is the quickest way to judge it.
Materials: ceramic, porcelain and marble
The UK retailer's guide separates three bodies. Ceramic is lighter, with moderate water absorption, and suits walls and feature panels. Porcelain is dense, with very low absorption, and handles floors, wet rooms and underfloor heating. Marble effect porcelain reproduces the look of green veined marble without the sealing, etching or staining risk of real stone. It goes so far as to say that almost all large format green tiles, and all green floor tiles worth buying, are porcelain. That is a retailer's view, and the listings here follow it: every tile on this page prints porcelain as the material except the Cottesloe marble.
The porcelain listings are Tamarama (glazed), St Kilda, Mooloolaba, Briq (unglazed), Meander and Matrix. Briq is the one to read most carefully. Its listing describes the matt surface as consistent through the body of the tile, with no glaze layer, so the colour runs through the body and is not an applied layer. Cottesloe is natural marble, honed, and its listing prints substantial variation in colour and texture, which it calls a unique appearance.
Tamarama: encaustic pattern
Tamarama is a modern take on a classic encaustic pattern, Australian made, with a matte finish and a cushioned edge. The Soft Sage listing is a 300 x 300mm porcelain tile, 6.3mm thick, with a glazed finish, and prints P3 with a note recommending P3 or greater for wet areas such as bathrooms, kitchens and laundries. Its wear line reads 4, described as suitable for floors in normal use areas with low risk of scratching, and its area line reads indoors and covered outdoor areas. The listing describes the appearance as uniform with minimal colour variation, which makes it a clean, flat sage and not a variegated one. The patterned tiles page shows the rest of the family.
Because it is a small square with a cushioned edge, Tamarama puts more grout lines on a floor than a large panel does. The listing recommends pairing tiles with underfloor heating for a warmer, drier floor.
St Kilda: octagon and dot
St Kilda brings classic period style with a modern twist. The green listings are an octagon with a green dot in matte white and in matte cream, and the listing text calls out tonal contrast between light and dark accents and a cushioned edge for a soft, tactile feel. The titles read 97 x 97mm, and the dimension line on the listing prints 300 x 300mm, which is the sheet size, so check the format on the listing before ordering. The St Kilda range page, the 97 x 97mm tiles page and the octagon and dot tiles page show the range and the format.
The wear line is the one to note. It prints 2, described as suitable for floors in light traffic areas with soft soled shoes, with a high risk of scratching. The listing says it is suited to bedrooms and bathrooms. That makes these a floor for a low traffic room and not for a hallway or a kitchen. The same range in other colours is covered on the range page.
Mooloolaba: penny rounds
Mooloolaba is a 20 x 20mm gloss penny round mosaic with colour blends. The green listings here are Marine and Mint. The listing prints a wear rating of 1, which it describes as not recommended for floors, and an area line of Indoors and Outdoors. The product copy says the tile suits interior wall and floor surfaces exposed to low-abrasion wear with bare or soft-soled shoes. It calls the tile a choice for a residential ensuite bathroom with no external entry. Those lines disagree with each other, and the page states them as printed.
The practical reading is this: Mooloolaba is a wall tile first, and any floor use belongs in a low abrasion room such as an ensuite with no external entry. For a floor that sees outdoor shoes, grit or heavy use, the porcelain and marble listings further down are a better fit. The penny round tiles and mosaic tiles pages show other mosaic options.
Cottesloe and Briq: mosaics for a feature floor
Cottesloe is a series of honed marble mosaics, delicate and sophisticated, in a 23mm penny round or a 35 x 150mm herringbone. The Ming Green listings come in both. The wear line reads 4, and the herringbone listing says it suits wall and floor surfaces exposed to heavy duty wear by regular traffic with normal footwear. It names entrances, laundries and patios, and notes that installation must be carried out by a licensed tiler. The listing prints fine grout lines of 3mm or less for the sharp edge tiles.
Briq Sage is an unglazed porcelain mosaic in 48 x 48mm chips on a 306 x 306mm sheet, available in five colourways in the range. It prints a matte finish, an application of Walls, Floors and Benchtops, a wear rating of 3 for light traffic, and a slip rating of Not rated. The listing says the range suits bathroom floors and shower recesses, kitchen splashbacks and feature walls. With no slip rating printed, it needs a confirmation before it goes in a shower recess, and the Briq range page has the full colour set.
Mosaic sheets carry many grout lines by design.
Meander and Matrix: small squares in green
Meander brings classic fish scale curves in a 200 x 200mm glazed porcelain with a calm matte finish, and its copy lists kitchens, bathrooms and laundries among the rooms it suits. The green listings print P3 described as moderate to high slip risk, suitable for flooring in dry areas, and a wear rating of 4, with an area line of indoors and covered outdoor areas. Matrix pairs richly veined marble looks with geometric patterns, in white, deep green and inky black. The green listings are a 200 x 200mm matte porcelain, again at P3 for dry areas and wear 4, in a plain and a tessellated version.
Both are 200 x 200mm, so both sit on the 200 x 200mm tiles page too. The marble look tiles page covers the family. For a bathroom floor, the dry area line is the one to weigh: P3 for dry areas is a rating for a floor that stays dry, not for a shower floor.
Slip ratings and wear lines
Listings print slip ratings under the P system from P1 to P5 and the R system. On this page, P3 appears on Tamarama, Meander and Matrix. Briq prints Not rated. Mooloolaba, Cottesloe and St Kilda print no slip line on the listings here. An Australian building materials retailer lists gloss, matte, honed and satin as the finishes for green, and advises checking slip ratings and finishes for wet zones, which is the point of reading each line.
Wear lines run separately and differ more on this page than on any of the other colour floor pages. Tamarama, Meander, Matrix and Cottesloe print 4, suitable for normal use areas. Briq prints 3, suitable for light traffic with normal shoes. St Kilda prints 2, suitable for light traffic with soft soled shoes. Mooloolaba prints 1, not recommended for floors. A bedroom or ensuite fits the low numbers, and a hallway, kitchen or laundry fits the 4.
The area lines also differ. Tamarama and Meander print indoors and covered outdoor areas, Mooloolaba prints indoors and outdoors, and Matrix and Meander are suitable for dry areas. Where the area line and the room do not match, pick a different tile.
Finish: gloss, matte and honed
An Australian building materials retailer says small gloss tiles suit splashbacks, matte suits floors, and textured suits statement walls. Gloss reflects light, matte is softer, honed has texture and satin has a subtle shine. On this page, Mooloolaba is gloss, Cottesloe and its marble mosaics are honed, and the rest are matte. The matte listings are the better choice for a floor, and the gloss one confirms the point: its own wear line is the lowest on the page.
Choosing a size
The formats here are small. Tamarama is 300 x 300mm, and the 300 x 300mm tiles page covers that size across every colour. Meander and Matrix are 200 x 200mm. St Kilda, Mooloolaba, Cottesloe and Briq are mosaics. There is no large format green tile with the floor tag at the moment, so a green floor on this page will have more grout lines than a 600 x 600mm tile floor. The UK retailer's guide notes that almost all large format green tiles are porcelain, and the 600 x 600mm tiles page shows what the larger formats look like in other colours.
The floor tag is applied to a small set of the green tiles on the site. Olive, emerald and other deeper shades sit on the green tiles page, where the application line on each listing says whether it suits a floor. If a green you like is not here, that page is the place to look, with the wear line checked first.
Pairing a green floor with the rest of the room
A national retailer's green bathroom blog shows green with floors in grey stone, speckled off white terrazzo, grey terrazzo and pale grey. It pairs those floors with mid-toned wood, a warm honey wooden vanity, brass and gold trims, and matching grout. For a green floor, the pairing flips: green underfoot with white or soft grey walls, and timber or brass in the fittings. The same retailer suggests cream grout and natural materials with sage.
Grout choices from the same blog give a rule of thumb. White grout keeps lines clean and crisp, mid-toned grey grout shows sleek lines without distracting contrast, and a matching blue green grout harmonises shades. On a floor, a matching or tonal grout keeps the surface calm, and a lighter grout draws the pattern, which suits a fish scale or an octagon. Cushioned edge tiles such as Tamarama, St Kilda and Mooloolaba have a softer edge and the listings recommend grout lines of 3mm or more.
Rooms and the ratings
The listings point to different rooms. A bedroom or ensuite floor can take the low wear listings, St Kilda and Mooloolaba, if the room sees only bare or soft soled feet. A laundry or entry floor points to Cottesloe's herringbone, whose listing names entrances and laundries. A bathroom floor that stays dry can take Matrix and Meander. The kitchen tiles page covers the kitchen use, and each listing here still needs its own slip, wear and area lines checked.
Cleaning and care
Most porcelain listings on this page print Easy to clean. A UK stone retailer says green glazed ceramic or porcelain is as easy to keep clean as any other glazed tile, with standard tile cleaner. Briq is unglazed, so its colour runs through the body, and the listing says it holds up on floors, walls and benchtops. The Cottesloe marble is natural stone, so the care line on the listing is the one to follow. The listings suggest ordering extra tiles over the measured area for cuts and waste.
Samples and ordering
Green changes with its light and its neighbours, so a sample laid in the room settles the shade. The range pages linked above show each collection's other colours and formats, and the green tiles page shows wall and floor tiles in the colour together.
